Lawn Mower Blade Sharpener Inforamtion

One of the joys of owning a home is looking after the yard.  For a well manicured and gorgeous yard, a lawn mower blade sharpener must be part of the yard tools owned.  Maintaining your mower’s engine will keep it running nicely, but it will not give a great cut on your lawn if the blades are in poor condition. 

Each spring, all householders pack away the snow shovels and snow blowers in trade for rakes and lawn mowers as the recently grown grass begins to appear.  Before getting on to the task of actually cropping grass, the mower must be inspected and maintained after being put away away for the past six months.  A good cleaning, fresh oil and gas and a close examination of the blades should take place at this time.  If the blade show chips, dents or peculiar bending, it should get replaced.  Using the mower will naturally, over time, dull the blade and spring time maintenance should include getting those blades in tip top shape. 

Using the turf mower blade sharpener of your choosing, you can easily get the blade back in as new condition.  First, the spark plug wire must be removed from the mower.  The engine will basically start if the blade is rotated by hand while the spark plug is still connected.  Place the mower on its side, being careful to keep the side housing the carburetor and the air filter facing upward to avoid any contamination of fuel or oil in the air filter.  Loosening the center bolt will enable you to remove the blade. 

Once the blade is removed, it should be marked in a manner the owner will know how to properly reload the blade.  After a good investigation of the blade to ensure it is in reasonable condition, you are prepared to sharpen the blade.  There are some types of sharpeners that can be used, depending on personal taste.  A combination grinder / sharpener may make the job less complicated, but is a reasonably dear investment.  A straightforward hand file is more than sufficient to do the job at a significantly lower cost.  Begin at the top side of the leading edge of the blade, using the push stroke to cut into the steel.  It should take only about fifty strokes total to finish the task. 

Keeping your yard clean cut is healthy and gorgeous ; made possible with the investment of just a bit time using the turf mower blade sharpener to get that blade in cutting order.